Fundamental Geometrical Principles
1.1 Description of workpiece points
Fundamentals
Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
15
;
;
<
<
3
3
3
3
P1 corresponds to X100 Y50
P2 corresponds to X-50 Y100
P3 corresponds to X-105 Y-115
P4 corresponds to X70 Y-75
=
;
3
3 3
3
The workpiece positions are required only in one plane for turning.
Points P1 to P4 are defined by the following coordinates:
P1 corresponds to X25 Z-7.5
P2 corresponds to X40 Z-15
P3 corresponds to X40 Z-25
P4 corresponds to X60 Z-35
To Next Page
Loading...
