Motion commands
4.12 Helical interpolation (G2/G3, TURN=)
Fundamentals
154 Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
6WDUWSRLQW
VW)XOOFLUFOH
QG)XOOFLUFOH
UG)XOOFLUFOH
(QGSRLQWDV
SDUWLDOURWDWLRQ
7DUJHWSRLQW
Programming the end point for helical interpolation
Please refer to circular interpolation for a detailed description of the interpolation parameters.
Programmed feedrate
For helical interpolation, it is advisable to specify a programmed feedrate override (CFC).
You can use FGROUP to specify, which axes are to be traversed with a programmed
feedrate. For more information please refer to the Path behavior section.
To Next Page
Loading...
