Siemens SINUMERIK 840Di sl - Parameters operating area

Motion commands
4.13 Involute interpolation (INVCW, INVCCW)
Fundamentals
Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
157
N20 INVCCW X32.77 Y32.77 CR=5 I-10 J0
;E. counterclockwise, end point, radius,
;center point relative to start point
N30 INVCW X10 Y0 CR=5 I-32.77 J-32.77
;Start point is end point from N20
;End point is start point from N20,
;radius, center point relative to new
;start point is equal to previous
;center point
...
Example of counterclockwise involute with end point over angle of rotation
Specification of end point via angle of rotation
; < 
$5 
5 
<
;
6WDUWLQJ
SRLQW
N10 G1 X10 Y0 F5000
;Approach start position
N15 G17
;Select X/Y plane
N20 INVCCW CR=5 I-10 J0 AR=360
;Counterclockwise involute, away from base
;circle (pos. angle setting) with
;one full rotation
...
Description
Programming methods
1. Direct programming of the end point with X, Y or X, Y, Z
2. Programming of the angle of rotation between the start and end vectors with AR=angle
(cf. also programming of the arc angle when programming circles). If the angle of rotation
is positive (AR > 0), the path on the involute moves away from the base circle; with a
negative angle of rotation (AR < 0), the path on the involute moves towards the base
circle. The maximum angle of rotation for AR < 0 is restricted by the fact that the end
point must always lie outside the base circle.