Fundamental Geometrical Principles
1.1 Description of workpiece points
Fundamentals
20 Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
Example of turning
The positions for points P1 to P4 in incremental dimensions are as follows:
=
;
3
3 3
3
G90 P1 corresponds to X25 Z-7.5 ;(with reference to the zero point)
G91 P2 corresponds to X15 Z-7.5 ;(with reference to P1)
G91 P3 corresponds to Z-10 ;(with reference to P2)
G91 P4 corresponds to X20 Z-10 ;(with reference to P3)
Note
When DIAMOF or DIAM90 is active, the path setpoint is programmed as a radius dimension
with G91.
To Next Page
Loading...
