Frames
6.6 Programmable scale factor (SCALE, ASCALE)
Fundamentals
Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
253
Use zero offset and rotation to set each of the workpiece zeroes, reduce the contour with a
scale and then call the subprogram up again.
;
<
r
N10 G17 G54
;Working plane X/Y, workpiece zero
N20 TRANS X15 Y15
;Absolute offset
N30 L10
;Machine large pocket
N40 TRANS X40 Y20
;Absolute offset
N50 AROT RPL=35
;Rotation in the plane through 35°
N60 ASCALE X0.7 Y0.7
;Scale factor for the small pocket
N70 L10
;Machine small pocket
N80G0 X300 Y100 M30
;Retraction, end of program
Substituting instruction, SCALE X Y Z
You can specify an individual scale factor for each axis, by which the shape is to be reduced
or enlarged. The scale refers to the workpiece coordinate system set with G54 to G57.
Notice
The SCALE command cancels all frame components of the previously activated
programmable frame.
To Next Page
Loading...
