Frames
6.7 Programmable mirroring (MIRROR, AMIRROR)
Fundamentals
258 Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
Example: Working plane G17 X/Y
The mirror (on the Y axis) requires a change of direction on X and is subsequently
programmed with MIRROR X0. The contour is then mirrored on the opposite side of the
mirror axis Y.
;
<
0,5525;
0,5525<
The mirror image refers to the coordinate axes set with G54 to G57.
Caution
The MIRROR command cancels all previously set programmable frames.
Additive instruction, AMIRROR X Y Z
A mirror image, which is to be added to an existing transformation, is programmed with
AMIRROR. The currently set or last programmed coordinate system is used as the
reference.
To Next Page
Loading...
