Frames
6.10 Deselect DRF (handwheel) offsets, overlaid motions (DRFOF, CORROF)
Fundamentals
268 Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
Note
CORROF is possible only from the parts program, not via synchronized actions.
Alarm 21660 is output if a synchronized action is active when the position offset is
deselected via parts program command CORROF(axis,"AA_OFF"). $AA_OFF is deselected
simultaneously and not set again. If the synchronized action becomes active later in the
block after CORROF, $AA_OFF remains set and a position offset is interpolated.
If a CORROF command has been programmed for an axis and this axis is active in a
different channel, then an axis replacement sends the axis to the other channel with machine
data 30552: AUTO_GET_TYPE = 0. This causes the DRF offset and any other position
offset to be deselected.
To Next Page
Loading...
