Tool offsets
8.3 Tool selection/tool call T
Fundamentals
Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
333
Programming
Tx or T=x or Ty=X
or
T0=
or
M06F2=... to F7=...
Parameter
Tx or T=x or Ty=x
Tool selection with T no.
x
x stands for T no.: 0-32000
T0=
Tool deselection
M06
Tool change, then tool T... and tool offset D are active
Number of tools: 1200
(depending on the machine manufacturer's configuration)
Machine manufacturer
The effect of the T number call is defined in machine data. Please refer to the machine
manufacturer's configuration.
Explanation
The free selection of the D No., "Flat D numbers", is used when tool management is done
outside the NC. In this case, the D numbers are created with the corresponding tool
compensation blocks without assignment to tools.
T can continue to be programmed in the parts program. However, this T has no reference to
the programmed D number.
Example:
Circular magazine with 12 locations and 12 single-edge tools.
To Next Page
Loading...
