Preface
Fundamentals
4 Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
Standard scope
This Programming Guide describes the functionality afforded by standard functions.
Extensions or changes made by the machine tool manufacturer are documented by the
machine tool manufacturer.
Other functions not described in this documentation might be executable in the control. This
does not, however, represent an obligation to supply such functions with a new control or
when servicing.
Further, for the sake of simplicity, this documentation does not contain all detailed
information about all types of the product and cannot cover every conceivable case of
installation, operation or maintenance.
Technical Support
If you have any technical questions, please contact our hotline:
Europe/Africa Asia/Australia America
Phone +49 180 5050 222 +86 1064 719 990 +1 423 262 2522
Fax +49 180 5050 223 +86 1064 747 474 +1 423 262 2289
Internet http://www.siemens.com/automation/support-request
E-Mail mailto:adsupport@siemens.com
Note
Country telephone numbers for technical support are provided under the following Internet
address:
Enter
http://www.siemens.com/automation/service&support
Questions about the manual
If you have any queries (suggestions, corrections) in relation to this documentation, please
fax or e-mail us:
Fax: +49 (0) 9131 / 98 - 63315
E-mail:
mailto:docu.motioncontrol@siemens.com
Fax form: See the reply form at the end of this publication
SINUMERIK Internet address
http://www.siemens.com/sinumerik
To Next Page
Loading...
