Tables
12.3 List of G functions/preparatory functions
Fundamentals
Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
481
Group 3: Programmable frame, working area limitation and pole programming
Name No. Meaning X m/n SAG MM
TRANS 1. TRANSLATION: translation, programmable X n
ROT 2. ROTATION: rotation, programmable X n
SCALE 3. SCALE: scaling, programming X n
MIRROR 4. MIRROR: Programmable mirroring X n
ATRANS 5. Additive TRANSLATION: additive translation, programming X n
AROT 6. Additive ROTATION: rotation, programmable X n
ASCALE 7. Additive SCALE: scaling, programming X n
AMIRROR 8. Additive MIRROR: Programmable mirroring X n
9. Unassigned
G25 10. Minimum working area limitation/spindle speed limitation X n
G26 11. Maximum working area limitation/spindle speed limitation X n
G110 12. Pole programming relative to the last programmed setpoint position X n
G111 13. Polar programming relative to origin of current workpiece coordinate
system
X n
G112 14. Pole programming relative to the last valid pole X n
G58 15. Programmable offset, absolute axial substitution X n
G59 16. Programmable offset, additive axial substitution X n
ROTS 17. Rotation with solid angles X n
AROTS 18. Additive rotation with solid angles X n
Group 4: FIFO
Name No. Meaning X m/n SAG MM
STARTFIFO 1. Start FIFO
Execute and simultaneously fill preprocessing memory
m Def.
STOPFIFO 2. STOP FIFO,
Stop machining; fill preprocessing memory until STARTFIFO is detected,
FIFO full or end of program
m
FIFOCTRL 3. FIFO CTRL,
Preprocessing memory control
m
Group 6: Plane selection
Name No. Meaning X m/n SAG MM
G17 1. Plane selection 1st - 2nd geometry axis m Def.
G18 2. Plane selection 3rd - 1st geometry axis m
G19 3. Plane selection 2nd - 3rd geometry axis m
To Next Page
Loading...
