Siemens SINUMERIK 840Di sl - Page 483

Tables
12.3 List of G functions/preparatory functions
Fundamentals
Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
483
Group 11: Exact stop, non-modal
Name No. Meaning X m/n SAG MM
G9 1. Velocity reduction, exact positioning X n
Group 12: Block change criteria at exact stop (G60/G09)
Name No. Meaning X m/n SAG MM
G601 1. Block change at exact stop fine m Def.
G602 2. Block change at exact stop coarse m
G603 3. Block change at IPO - end of block m
Group 13: Workpiece measuring inch/metric
Name No. Meaning X m/n SAG MM
G70 1. Input system inches (lengths) m
G71 2. Input system metric (lengths) m Def.
G700 3. Input system in inches; inch/min
(lengths + velocity + system variable)
m
G710 4. Input system, metric; mm; mm/min
(lengths + velocity + system variable)
m
Group 14: Workpiece measuring absolute/incremental
Name No. Meaning X m/n SAG MM
G90 1. Absolute dimensions m Def.
G91 2. Incremental dimension input m
Group 15: Feed type
Name No. Meaning X m/n SAG MM
G93 1. Inverse-time feedrate 1/rpm m
G94 2. Linear feed mm/min, inch/min m Def.
G95 3. Revolutional feedrate in mm/rev, inch/rev m
G96 4. Constant cutting speed (type of feed as for G95) ON m
G97 5. Constant cutting speed (type of feed as for G95) OFF m
G931 6. Feedrate specified by travel time, deactivate constant path velocity m
G961 7. Constant cutting speed (type of feed as for G94) ON m
G971 8. Constant cutting speed (type of feed as for G94) OFF m
G942 9. Freeze linear feedrate and constant cutting rate or spindle speed m