Siemens SINUMERIK 840Di sl - Page 505

Tables
12.4 List of predefined subprograms
Fundamentals
Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
505
24. Tool management
1st parameter 2nd parameter 3rd
parameter
Explanation
DELT STRING[32]: Tool
designation
INT: Duplo
number
Delete tool. Duplo number can be
omitted.
GETSELT VAR INT:
T number (return
value)
INT: Spindle
number
Get selected T number. If no spindle
number is specified, the command
for the master spindle applies.
SETPIECE INT: Count INT: Spindle
number
Takes account of set piece number
for all tools assigned to the spindle.
If no spindle number is specified, the
command for the master spindle
applies.
SETDNO INT: Tool number T INT: Tool
edge no.
INT: D No. Set D no. of tool (T) and its tool
edge to new
DZERO Set D numbers of all tools of the TO
unit assigned to the channel to
invalid
DELDL INT: Tool number T INT: D No. Delete all additive offsets of the tool
edge (or of a tool if D is not
specified)
SETMTH INT: Tool-holder
no.
Set toolholder no.
POSM INT: Location no.
for positioning
INT: No. of the
magazine to
be moved
INT:
Location
number of
the internal
magazine
INT:
Magazine
number of
the internal
magazine
Position magazine
SETTIA VAR INT:
Status=result of
operation (return
value)
INT: Magazine
number
INT: Wear
grouping no.
Deactivate tool from wear group
SETTA VAR INT:
Status=result of
operation (return
value)
INT: Magazine
number
INT: Wear
grouping no.
Activate tool from wear group
RESETMON VAR INT:
Status=result of
operation (return
value)
INT: Internal T
no.
INT: D no. of
tool
Set actual value of tool to setpoint
#) The keyword is not valid for SINUMERIK FM-NC.