Siemens SINUMERIK 880 GA2 Programming Guide

11 Programming of Cycles 05.91
11.11 Part program handling
Example: @f22 in the case of a block with ”normal” comment
The block is:
N10 G01 X100 ( DRILLING AND MILLING ) Y50 L
F
a) Word five is to be read:
The word is contained in the comment. The output R parameters are as follows:
R
y
: 2 Word contained in the comment
R
y
+1 to R
y
+5 : 0
b) Word seven is to be read:
In this case, left bracket + blank, right bracket + blank and all other blanks are
considered to be word boundaries. Consequently, word seven is ”Y50”.
Output R parameters:
R
y
: 0 No error
R
y
+1 : 89 (”Y”) Address letter
R
y
+2 : 0 Extended address No
R
y
+3 : 0 No extended address
R
y
+4 : 0 Operator not available
R
y
+5 : 50 Value
11–62
© Siemens AG 1991 All Rights Reserved 6ZB5 410-0HD02
SINUMERIK 880, (PG)

Siemens SINUMERIK 880 GA2 Specifications

General

Brand	Siemens
Model	SINUMERIK 880 GA2
Category	Control Unit
Language	English