Siemens SINUMERIK 880 GA2 Programming Guide

01.93 13 Program Key SINUMERIK 880/880 GA2
13.2 Overview of G commands for SINUMERIK 880/880 GA2
G59 2
nd
programmable zero offset
G60 Feedrate reduction, exact stop fine
G62 Contouring, block transition with speed decrease
G63 Tapping without encoder, feedrate override 100 %
G64 Contouring, block transition without speed decrease
G68 Absolute dimensioning along shortest path (rotary axis only)
G70 Inch input system
G71 Metric input system
G74 Reference point approach by program
G80 Clearing G81 to G89
G81 Call cycle L81: Drilling, centering
G82 Call cycle L82: Drilling, spot facing
G83 Call cycle L83: Deep-hole drilling
G84 Call cycle L84: Tapping with/without encoder
G85 Call cycle L85: Boring 1
G86 Call cycle L86: Boring 2
G87 Call cycle L87: Boring 3
G88 Call cycle L88: Boring 4
G89 Call cycle L89: Boring 5
G90 Absolute dimensioning
G91 Incremental dimensioning
G92 P . . Relationship between working diameter and unit diameter with cylindrical
interpolation
S . . Set spindle speed limitation
T . . Smoothing and feed run-up time when thread cutting
G94 Feedrate under address F in mm/min or inch/min
G95 Feedrate under address F in mm/rev or inch/rev
G96 Feedrate under address F in mm/rev or inch/rev and constant cutting speed under
address S in m/min or feed/min
G97 Cancel G96, store last setpoint speed of G96
G110 Polar coordinate programming, adopt last programmed position as new centre point
G111 Polar coordinate programming, pole programming with angle and radius
G130 Deselect transformation TRANSMIT or
deselect transformation coordinate rotation 2D/3D
G131 Transformation TRANSMIT
G133 Transformation coordinate rotation 2D
G135 Transformation coordinate rotation 3D
G147 Approach contour with straight line
G148 Exit contour with straight line
G150 Deselect coupled motion
G151 1
st
coupled motion combination
G152 2
nd
coupled motion combination
G153 3
rd
coupled motion combination
G154 4
th
coupled motion combination
G155 5
th
coupled motion combination
G156 6
th
coupled motion combination
G157 7
th
coupled motion combination
G158 8
th
coupled motion combination
G159 9
th
coupled motion combination
G171 Fill FIFO buffer (SINUMERIK 880 GA2 only)
G175 Update zero offset, length compensation and angle of rotation in every block
G176 Freeze length compensation, zero offset and angle of rotation
G195 Feedrate in mm/rev referred to a rotary axis
G200 Axis synchronization with change of channel
G201 Select synchronous spindle
© Siemens AG 1991 All Rights Reserved 6ZB5 410-0HD02 13–3
SINUMERIK 880, (PG)

Siemens SINUMERIK 880 GA2 Specifications

General

Brand	Siemens
Model	SINUMERIK 880 GA2
Category	Control Unit
Language	English