Siemens siprotec 7SA522 - Page 152

Functions
6-4 7SA522 Manual
C53000-G1176-C119-2
Exiting the
Setting Mode
If an attempt is made to exit setting modification mode using the key or the key,
the message $UH\RXVXUH" will be displayed followed by the responses <HV1R
and (VFDSH (see Figure 6-4). If the response <HV is selected, modification of settings
can be confirmed by pressing the key. To cancel pending modifications to settings
and exit setting modification mode, the response 1R must be selected. Press the
key until the response 1Ris highlighted. Press the key to confirm and exit. Incor-
rect entries may be retracted in this manner. To remain in the setting modification
mode, press the key until the response (VFDSHis highlighted. Press the key
to confirm, and the user can remain in setting modification mode without down-loading
modifications.
Figure 6-4 Ending the setting mode using the front control panel
From PC
with
DIGSI
®
4
Using DIGSI
®
4 to
modify settings.
To select a function, double-click on 6HWWLQJV, and then double-click on the desired
setting function (e.g., 3RZHU6\VWHP'DWD is selected by double-clicking 6HW
WLQJV, and then double-clicking 3RZHU6\VWHP'DWD as illustrated in Figure 6-5).
K450.gif
Figure 6-5 Navigating using DIGSI
®
4 — example
MENU
ENTER
ENTER
ENTER
ENTER
$UH\RXVXUH"
!<HV1R(VFDSH
ENTERENTER
6HWWLQJVDUHRN
!&RQWLQXH
: