Initial Inspections
3-57SA522 Manual
C53000-G1176-C119-2
3.3 User Interface
3.3.1 Operation Using the Operator Control Panel
Operator Control
Panel
The device has a hierarchically structured operating tree, within which movements
and actions are made using the , , , keys and the , , , and
keys on the front panel.
The brief discussions below illustrate the navigation techniques using the integrated
operations in the operator control panel. Some typical operations are covered. For
easier understanding, the accompanying figures show the entire contents of the men-
us, while only a limited number of lines can be seen in the display at any time.
Reading Ordering
Number/Version
To view the complete ordering number of the device, the version of firmware imple-
mented, and the serial number:
q
When the device is ready for operation, first press the key. The 0$,10(18 ap-
pears.
q
Using the key, select the menu item 6HWWLQJV, and move to the device settings
using the key. The 6(77,1*6 menu appears, as shown in Figure 3-1.
q
Using the key, select the menu item 6HWXS([WUDV and switch to the selection
6(783(;75$6 using the key. See Figure 3-2.
Figure 3-1 Main menu and sub-menu 6(77,1*6
q
Using the key, select the menu 0/)%9HUVLRQ and view the selection 0/)%
9(56,21 using the key.
The device-specific data appear in two or three lines. Press the key as necessary
to view all of the data:
MENU
ENTER
CTRL
ESC
MENU
0$,10(18
$QQXQFLDWLRQ²!
0HDVXUHPHQW²!
&RQWURO²!
!6HWWLQJV²!
7HVW'LDJQRVH²!
6(77,1*6
'HYLFH&RQILJ²!
0DVNLQJ,2²!
36\VWHP'DWD²!
*URXS$²!
*URXS%²!
*URXS&²!
*URXS'²!
&KDQJH*URXS²!
2VF)DXOW5HF²!
!6HWXS([WUDV²!
'HYLFH²!
To Next Page
Loading...
Need help?
General
