Siemens SIRIUS 3RW52 - Response to Bus Errors; Control Via Digital Input

Functions
8.10 Response to bus errors / Control via digital input
SIRIUS 3RW52 Soft Starter
Equipment Manual, 04/2020, A5E35630451002A/RS-AE/005
147
8.10 Response to bus errors / Control via digital input
Requirements
Ⴠ 3RW52 soft starter from firmware version V2.0.1
Note
3RW52 soft starter with firmware version earlier than V2.0.1:
The 3RW52 soft starter responds in accordance with the setting "Manual activation".
Operating principle
The parameter "Control via digital input" is only relevant when using a
3RW5 communication module. The parameter is helpful, for example, for applications in
which the bus connection serves mainly for observation and monitoring purposes.
The parameter defines how the master control function behaves on failure of the bus
connection or a CPU stop. A failure of the bus connection or a CPU stop can also occur in
the operating mode "manual - local", for example when observing or monitoring via the bus
connection. You can use the parameter to disable a switchover to the "Automatic" mode and
operating mode "manual - bus".
Setting options
Ⴠ Parameterization via key combination on the 3RW52 Soft Starter (Page 108)
Ⴠ 3RW5 HMI High Feature (accessory) with firmware version V3.0 or higher
Access protection to 3RW5 HMI High Feature is not active or has been reset.
Menu: "Parameters > Soft Starter > Additional parameters > Control via digital input"