Siemens SIRIUS 3RW52 - Graphic Display of Measured Values on the 3 RW5 HMI High Feature

Functions
8.12 High Feature 3RW5 HMI
SIRIUS 3RW52 Soft Starter
156 Equipment Manual, 04/2020, A5E35630451002A/RS-AE/005
8.12.1.2 Graphic display of measured values on the 3RW5 HMI High Feature
Requirements
Ⴠ 3RW5 HMI High Feature (accessory) with firmware version V3.0 or higher
Operating principle
The 3RW52 soft starter supports the graphical display of the measured values
"Phase currents (%)" and "Phase currents (rms)". These measured values can be presented
as bar or line charts on the display of the 3RW5 HMI High Feature.
The following measured values can be displayed in the charts:
Ⴠ Phase current IL1 (%) and (rms)
Ⴠ Phase current IL2 (%) and (rms)
Ⴠ Phase current IL3 (%) and (rms)
Ⴠ Phase current average (%) and (rms)
Procedure for displaying bar charts
1. Select the menu item "Monitoring > Measured values > Phase currents (%) /
Phase currents (rms) > Show bar chart".
Depending on the menu item selected, the current values of the 3 phase currents (%) or
phase currents (rms) and the average value are displayed graphically in a bar chart.
2. Use the left and right navigations keys of the 3RW5 HMI High Feature to switch the view
between Phase currents (%) and Phase currents (rms).
3. Press the ESC key to exit the bar chart view.
The example chart shows the current 3 phase currents (L1/L2/L3) and the associated
average value as a percentage. The scaling of the x-axis is 200%.