Maintenance and servicing
10.4 Restore factory setting
SIRIUS 3RW52 Soft Starter
202 Equipment Manual, 04/2020, A5E35630451002A/RS-AE/005
10.4.2 Restoring the factory settings with the Master RESET button via
3RW5 HMI High Feature
Requirements
Ⴠ 3RW5 HMI High Feature (accessory)
Ⴠ Make sure that the motor is switched off and that you do not start the motor while
restoring the factory settings. To ensure the quickest and most fault-free restoration of the
factory setting, it is recommended that you disconnect the main voltage
(operating voltage) at the 3RW52 soft starter.
Ⴠ Free access to the Master RESET key of the 3RW5 HMI High Feature.
Removing the High Feature 3RW5 HMI (Page 62)
Ⴠ 3RW5 HMI High Feature is connected with the 3RW52 soft starter via the HMI connecting
cable.
Procedure
1. Press the Master RESET key on the rear of the 3RW5 HMI High Feature.
The menu for restoring the factory setting appears on the display.
2. Select the desired menu item.
– Soft starter
– Communication module
– HMI High Feature
– All devices
3. Confirm the menu item by pressing the OK key.
Result
The factory setting of the selected device or all devices is restored.
Note the effects of the factory settings (Page 199).
To Next Page
Loading...
