Siemens SIRIUS 3RW52 - Diagnostics of the 3 RW52 Soft Starter with the 3 RW5 HMI High Feature

Messages and diagnostics
9.6 Diagnostics of the 3RW52 soft starter with the 3RW5 HMI High Feature
SIRIUS 3RW52 Soft Starter
182 Equipment Manual, 04/2020, A5E35630451002A/RS-AE/005
9.6 Diagnostics of the 3RW52 soft starter with the
3RW5 HMI High Feature
With the diagnosis, you can display different statuses (Diagnosis state, Device state),
Statistic data and Maximum pointer of the 3RW52 soft starter. There is also the Self-test
(user-test) (Page 187) and Logbooks (Page 191).
Requirements
Ⴠ 3RW5 HMI High Feature (accessory)
Ⴠ Menu: "Diagnosis > Soft Starter"
Parameters
Diagnostic value
Description
Diagnosis state Shows all active warnings and faults.
You can acknowledge errors here (Manual RESET).
Device state Type of connection If the 3RW52 soft starter is supplied with main voltage (operating
voltage) and a motor is connected, the type of connection is
automatically detected.
x Type of motor connection unknown
x Type of motor connection standard (inline)
x Motor connection type inside delta
Rotation direction
x Unknown main power direction
(direction of phase rotation of the power system of the main
voltage (operating voltage) at terminals L1/L2/L3 not detected)
x Clockwise
x Counter-clockw.
Ready (automatic)
Motor CW
Starting mode active
Stopping mode active
Cooling time active
Current limiting active
Input control
Input 1
Maximum pointer reset
CPU/Master STOP
Automatic mode
Operating mode manual - bus
Operating mode manual - local
Factory settings restored
Main power rotation right