Siemens SIRIUS 3RW52 - Removing the High Feature 3 RW5 HMI

Mounting and dismantling
4.4 Installing, mounting and removing the 3RW5 HMI
SIRIUS 3RW52 Soft Starter
62 Equipment Manual, 04/2020, A5E35630451002A/RS-AE/005
4.4.4 Removing the High Feature 3RW5 HMI
Requirements
Ⴠ Installed 3RW5 HMI High Feature (accessory) (Page 61)
Ⴠ Flat-bladed screwdriver
Procedure
NOTICE
Damage to sealing surfaces.
Make sure that the sealing surfaces are not damaged by the screwdriver.
Illustration similar
Ⴠ Release the 3RW5 HMI High Feature using a flat-bladed screwdriver in the groove
provided
཰ / ཱ.
Ⴠ Pull the 3RW5 HMI High Feature far enough out of the 3RW52 soft starter
ི to gain
access to the HMI connecting cable.
Ⴠ Unfasten the retaining elements of the HMI connecting cable
ཱི and pull the HMI
connecting cable out of the 3RW52 soft starter
ུ.
Result
You have removed the 3RW5 HMI High Feature. You can install the
3RW5 HMI High Feature on a surface (Page 73) or in a cabinet door (Page 67) or you can
install a new 3RW5 HMI High Feature (Page 61).