Siemens SIRIUS 3RW52 - Installing, Mounting and Removing the 3 RW5 HMI; Installing the Standard 3 RW5 HMI in 3 RW52 Soft Starter

Mounting and dismantling
4.4 Installing, mounting and removing the 3RW5 HMI
SIRIUS 3RW52 Soft Starter
58 Equipment Manual, 04/2020, A5E35630451002A/RS-AE/005
4.4 Installing, mounting and removing the 3RW5 HMI
4.4.1 Installing the Standard 3RW5 HMI in 3RW52 soft starter
Requirements
Ⴠ 3RW5 HMI Standard (accessory)
Ⴠ HMI connecting cable, 0.1 m (accessory)
Ⴠ Hinged cover for 3RW52 with cutout for 3RW5 HMI Standard (accessory) or Cut out the
hinged cover for 3RW5 HMI (Page 75)
Procedure
NOTICE
Material damage caused by electrostatic charge.
Note the information in chapter ESD Guidelines (Page 15).
Illustration similar
Ⴠ Make sure that the locking switch on the rear of the 3RW5 HMI Standard is in the
required position.
You will find further information in chapter Standard 3RW5 HMI (Page 149).
Ⴠ Observe the coding of the plug and socket
཰ / ི.
Ⴠ Lock the connector in the socket
ཱ.