Functions
8.12 High Feature 3RW5 HMI
SIRIUS 3RW52 Soft Starter
Equipment Manual, 04/2020, A5E35630451002A/RS-AE/005
157
Procedure for displaying line charts
Operation display
1. Select the measured value to be displayed in the operation display and press the right
navigation key of the 3RW5 HMI High Feature.
The selected measured value is shown graphically in a line chart.
2. Use the left and right navigations keys of the 3RW5 HMI High Feature to switch the view
between Phase currents (%) and Phase currents (rms).
3. Press the ESC key to exit the line chart view.
"Monitoring" menu
1. Select the menu item "Monitoring > Measured values > Phase currents (%) /
Phase currents (rms)".
2. Select the phase current to be displayed and press the right navigation key of the
3RW5 HMI High Feature.
The selected phase current is shown graphically in a line chart.
3. Use the left and right navigations keys of the 3RW5 HMI High Feature to switch the view
between Phase currents (%) and Phase currents (rms).
4. Press the ESC key to exit the line chart view.
The sample chart shows the current phase current I IL1 as a percentage. The scaling of the
y-axis is 200%.
If the measured value exceeds the limit of the scaling (200% in the example), the line
extends parallel with the x-axis and is displayed red in that area.
To Next Page
Loading...
