Siemens SIRIUS 3RW52 - Connect the 3 RW52 soft starter to the main circuit connection (line side; motor side)

Mounting and dismantling
4.4 Installing, mounting and removing the 3RW5 HMI
SIRIUS 3RW52 Soft Starter
64 Equipment Manual, 04/2020, A5E35630451002A/RS-AE/005
Procedure with door mounting kit IP65
Ⴠ Remove the protective film from the adhesive tape on the seal and secure the seal on the
rear side of the 3RW5 HMI Standard
཰.
Ensure that the seal does not overlap.
Ⴠ Place the 3RW5 HMI Standard in the cutout of the control cabinet door
ཱ.
Ⴠ Continue to screw the screws into the fixing brackets
ི until they protrude approx.
10 mm at the front. Fasten the fixing brackets onto the 3RW5 HMI Standard
ཱི.
Ⴠ Tighten the 3RW5 HMI Standard with a tightening torque of 0.3 ... 0.35 Nm
ུ.
Ensure that all of the screw heads are in contact with the fixing bracket.