Getting started
24
Siemens Building Technologies
Fire Safety & Security Products 01.2008
When starting SISTORE MX for the first time, all analogue cameras found by an
automatic check of video inputs should be displayed. If this is not the case, one of
the following reasons is possible:
z an error occurred during the installation of SISTORE MX
z the connection of the cameras to SISTORE MX is faulty (connector not plugged
in properly)
z the camera is not sending any signal
In the first case, you should contact your installer.
9.4 Toolbar
The software functions can be called up by selecting the appropriate button in the
SISTORE MX toolbar.
Fig. 5 SISTORE MX toolbar
1 Login
See Section
9.2 Login.
2 View logbook
3 Next group
See Section
10.11 Display camera group .
4 Automatic scan
5, 6 Video display modes
See Section
9.7: Video image display modes
7 Show event window
8 Show map
See Section
10.12 Site plan
9 Audio on/off
See Section
10.2 Audio on/off
10 Start recording: Starting the recording
See Section
12 Starting and stopping recording
11 Stop recording: Stopping the recording
See Section
12 Starting and stopping recording
12 Playback: Starting playback.
13 Online help
To Next Page
Loading...
Need help?
General
