Getting started
26
Siemens Building Technologies
Fire Safety & Security Products 01.2008
The available disk capacity is shown in four stages in the status line, two of these
are shown as a graph display.
Stage 1: The disk capacity which is already occupied is shown as a percentage
in the form of a blue bar.
Stage 2: As stage 1, but showing the estimated remaining recording time. This is
an estimate because the system does not display the actual remaining
recording time but, instead, measures the data volume that can still be
saved and displays it as an estimated available remaining recording
time. The system uses the actual settings (frame rate, image size) as a
basis for this estimate.
Stage 3: Shows in text form the designation of the hard disk where current
recording is taking place, the disk's available capacity and its maximum
capacity.
Stage 4: Shows in text form the available capacity and the maximum capacity of
all hard disks authorised for recording.
The display form set last is stored and used automatically again when SISTORE
MX is restarted. This does not apply to SISTORE MX RemoteView.
RemoteView status displays
There are several server-related status displays on the RemoteView. In multi-
server mode, the server whose status is to be displayed must be selected in the list
of cameras.
The status displays always relate to the server that is associated with the selected
camera.
The server-related status displays include:
z Time
z Alarm outputs
z HDD capacity indicator
z Recording duration
z Start/stop of recording
Global status displays for all servers include:
z Motion
z Alarm
z Loss of video
z Camera tamper
z Error
z Connection
To Next Page
Loading...
Need help?
General
