Siemens SITRANS FUS080 - Page 76

Parameter lists
A.3 Diagnostic
SITRANS FUS080 transmitter
74 Operating Instructions, 07/2012, A5E03059912-02
Modbus
Address
Parameter Default
value
Value
range
Access
level
Description
21 209 Reset consumption log
fault
No No, Yes R/W Reset the consumption fault.
Caused by too low or too high
consumption in the log interval
3 210 Path 1 alarm output
enable
Yes No, Yes R/W Select 'Yes' to enable current alarm on
alarm output / call-up
211 Path 1 fault hours e.g. 36 h Read; Total hours fault active
40258 212 Path 1 fault counter e.g. 4 0 ... 65535 Read Total number of faults.
Valid only if alarm is enabled
40259 213 Path 1 fault appears Last fault
appear
date
dd-mm-
yyyy,
hh:mm:ss
Read Last time the fault appeared.
Valid only if alarm is enabled
40262 214 Path 1 fault disappears Last fault
disappear
date
dd-mm-
yyyy,
hh:mm:ss
Read Last time the fault disappeared.
Valid only if alarm is enabled
4 215 Path 2 alarm output
enable
Yes No, Yes R/W Select 'Yes' to enable active alarm on
alarm output / call-up.
Valid only for 2-path solutions
40265 216 Path 2 fault hours e.g. 36 h Read; Read Total hours fault active.
Valid only for 2-path solutions and if
alarm is enabled
40266 217 Path 2 fault counter e.g. 4 0 ... 65535 Read Total number of faults.
Valid only for 2-path solutions and if
alarm is enabled
40267 218 Path 2 fault appears Last fault
appear
date
dd-mm-
yyyy,
hh:mm:ss
Read First time the fault appeared.
Valid only for 2-path solutions and if
alarm is enabled
40270 219 Path 2 fault disappears Last fault
disappear
date
dd-mm-
yyyy,
hh:mm:ss
Read Last time the fault disappeared.
Valid only for 2-path solutions and if
alarm is enabled
5 220 Dual slope alarm output
enable
Yes No, Yes R/W Select 'Yes' to enable active alarm on
alarm output / call-up
40273 221 Dual slope fault hours e.g. 0 h 0 ... 65535 Read Total hours fault active.
Valid only if alarm is enabled
40274 222 Dual slope fault counter e.g. 0 0 ... 65535 Read Total number of faults.
Valid only if alarm is enabled
40275 223 Dual slope fault appears e.g. 0 h 0 ... 65535 Read First time the fault appeared.
Valid only if alarm is enabled
40278 224 Dual slope fault
disappears
e.g. 0 0 ... 65535 Read Last time the fault disappeared.
Valid only if alarm is enabled
6 225 Parameter checksum
alarm output enable
Yes No, Yes R/W Select 'Yes' to enable active alarm on
alarm output / call-up
40281 226 Parameter checksum
fault hours
e.g. 0 h 0 ... 65535 Read Total hours fault active.
Valid only if alarm is enabled
40282 227 Parameter checksum
fault counter
e.g. 0 0 ... 65535 Read Total number of faults. Valid only if
alarm is enabled