Sierra Wireless FX30 - Factory Reset AT Commands

AT Commands Reference
Rev 4 March 2019 71 41110030
Factory Reset AT Commands
For instructions on resetting the FX30 to factory default setting, see Reset to Factory Default Settings on page 36.
AT!FWD=FACTORYRECOVERY
Enables or disables the factory default
recovery mechanism.
Note: This command does not
perform a factory reset. It enables the
reset button to perform a factory reset
when it is pressed and held.
To set :
AT!FWD=FACTORYRECOVERY,<status>
where <status> can be either: ENABLE, DISABLE
Returned values are:
• OK (if a valid <status> is entered)
• ERROR (if an invalid <status> is entered)
Example:
AT!FWD=FACTORYRECOVERY,DISABLE
OK
Table C-2: FX30 AT Commands
Command Description