90 007-5832-002
B: Safety Information and Regulatory Specifications
9. Do not attempt to service this product yourself except as noted in this guide. Opening or
removing covers of node and switch internal components may expose you to dangerous
voltage points or other risks. Refer all servicing to qualified service personnel.
10. Unplug this product from the wall outlet and refer servicing to qualified service personnel
under the following conditions:
• When the power cord or plug is damaged or frayed.
• If liquid has been spilled into the product.
• If the product has been exposed to rain or water.
• If the product does not operate normally when the operating instructions are followed.
Adjust only those controls that are covered by the operating instructions since improper
adjustment of other controls may result in damage and will often require extensive work
by a qualified technician to restore the product to normal condition.
• If the product has been dropped or the cabinet has been damaged.
• If the product exhibits a distinct change in performance, indicating a need for service.
11. If a lithium battery is a soldered part, only qualified SGI service personnel should replace
this lithium battery. For other types, replace it only with the same type or an equivalent type
recommended by the battery manufacturer, or the battery could explode. Discard used
batteries according to the manufacturer’s instructions.
12. Use only the proper type of power supply cord set (provided with the system) for this unit.
13. Do not attempt to move the system alone. Moving a rack requires at least two people.
14. Keep all system cables neatly organized in the cable management system. Loose cables are a
tripping hazard that cause injury or damage the system.
To Next Page
Loading...
Need help?
General
