System Control Overview
007-5832-002 19
This refers to rack 1, IRU 1, CMC.
2. Power up your UV system using the power-on command, as follows:
CMC:r1i1c> power on
Note that the larger a system is, the more time it will take to power up completely. Information on
booting Linux from the shell prompt is included at the end of the subsection (“Monitoring Power
On” on page 19).
Monitoring Power On
Open a separate window on your PC or workstation and establish another connection to the SMN
or CMC and use the uvcon command to open a system console and monitor the system boot
process. Use the following steps:
CMC:r1i1c> uvcon
uvcon: attempting connection to localhost...
uvcon: connection to SMN/CMC (localhost) established.
uvcon: requesting baseio console access at r001i01b00...
uvcon: tty mode enabled, use ’CTRL-]’ ’q’ to exit
uvcon: console access established
uvcon: CMC <--> BASEIO connection active
************************************************
******* START OF CACHED CONSOLE OUTPUT *******
************************************************
******** [20100512.143541] BMC r001i01b10: Cold Reset via NL
broadcast reset
******** [20100512.143541] BMC r001i01b07: Cold Reset via NL
broadcast reset
******** [20100512.143540] BMC r001i01b08: Cold Reset via NL
broadcast reset
******** [20100512.143540] BMC r001i01b12: Cold Reset via NL
broadcast reset
******** [20100512.143541] BMC r001i01b14: Cold Reset via NL
broadcast reset
******** [20100512.143541] BMC r001i01b04: Cold Reset via NL....
Note: Use CTRL-] q to exit the console.
To Next Page
Loading...
Need help?
General
