10 GB
Do not pull the power plug out of
the electrical outlet by the power
cord.
Protect the product, its power
cord and power plug against
dust, direct sunlight, dripping and
splashing water.
Store the product in a cool, dry
place, protected from moisture
and out of the reach of children.
Protect the product against heat.
Do not place the product close to
open flames or heat sources such
as stoves or heating appliances.
Before first use
Remove the packaging. Check if all parts are
complete.
During production, some parts are covered with
a thin oil film for their protection. Before first use,
operate the product without any batter so that
any potential residues evaporate.
Clean the product and its accessories
(see “Cleaning and care”).
NOTES:
The first few times the product is heated up, a
faint odour may be present. Ensure sufficient
ventilation in the area.
Discard the first set of waffles/donuts.
Assembly
mWARNING! Risk of electric shock. Before
installing/removing the plates
11a
11b
12
13
:
Disconnect the power plug
4
from the socket-
outlet.
DANGER! Risk of burns. Do not change/
remove the plates
11a
11b
12
13
right after
operation. Let the product cool first.
Installing the plates
Open the lock
1
. Open the product.
Place the inner catch
10
of the chosen plate into
the large hook catches
7
.
Push down the plate until it clicks in place.
Repeat on the other side of the product.
NOTES:
Install only plates of the same type.
Motif plate Installation (Fig. B)
Concave
11a
Bottom section of product
Convex
11b
Upper section of product
Removing the plates
Open the lock
1
. Open the product.
Pull the release levers
8
. Remove the plate.
Repeat on the other side of the product.
To Next Page
Loading...
Need help?
General
