Simplex 4100ES - Earth Fault Searching from the Front Panel

D-3
This section describes how to conduct an Earth Fault Search, from selecting the
appropriate access code to correcting the fault.
The panel must be at the appropriate access level in order to run diagnostics. If necessary,
refer to the InfoAlarm Operator Manual supplied with the 4100ES, for the detail of how
to log in at a higher level than 1.
You can now open the diagnostic menu as described in the next topic.
To start an Earth Fault Search, open the Main Menu on the InfoAlarm. Select the
Service/Diagnostics menu.
Select Earth Fault search in the diagnostics menu.
Continued on next page
Earth Fault Searching from the Front Panel
Overview
Access Level
Selection
Starting the Earth
Fault Search