E-1
This appendix lists devices that have been approved as compatible devices for use with
the 4100ES FIP. It lists the devices approved for use with the IDNet and shows the
number allowed per loop.
Refer to the page number listed in this table for information on a specific topic.
Topic See Page #
List of Approved Devices
E-1
Compatible Detectors, IDNET
E-4
Compatible Addressable Field Devices, IDNet
E-5
Simplex Range - Conventional Detectors
4098-9413 Heat detector Type A
4098-9414 Heat detector Type B
4098-9415 Heat detector Type C
4098-9416 Heat detector Type D
2098-9201 Photoelectric smoke detector
2098-9576 Ionisation smoke detector
Detector Type 4100-5004
8 Zone
Module
2190-9156
Monitor ZAM
4090-9101
Monitor ZAM
4098-9601EA Photoelectric 30 20 20
4098-9603EA Ionisation 30 20 20
4098-9618EA Heat Type A 30 20 20
4098-9619EA Heat Type B 30 20 20
4098-9621EA Heat Type D 30 20 20
Tyco Range - Conventional Detectors
Detector Type 4100-5004
8 Zone
Module
2190-9156
Monitor ZAM
4090-9101
Monitor ZAM
614CH CO/Heat Detector 37 25 25
614I Ionisation Detector 40 29 29
614P Photo-electric
Detector
28 19 19
T614 Heat Detectors
– Type A, B, C, D
30 20 20
System Sensor Range - Conventional Detectors
Detector Type 4100-5004
8 Zone
Module
2190-9156
Monitor ZAM
4090-9101
Monitor
ZAM
885WP-B Weatherproof Heat
Detector Type B @
40 40 40
@ Remote indicator output cannot be wired in common with Tyco 614 series
or the Minerva M614 series (and most other Tyco/Olsen) detectors.
Continued on next page
Appendix E
Compatible Actuating Devices
Introduction
In this Chapter
List of Approved Devices
To Next Page
Loading...
Need help?
General
