2-1
4100ES cabinets are available in one-, two-, and three-bay sizes. Each can be equipped
with a solid or windowed door. This chapter describes how to mount all types of 4100ES
cabinets to a wall, and how to mount system card bays into the cabinets, modules to bays,
etc.
FIPs are assembled to order within the factory. Steps 2 to 6 below are therefore not
typically required in the field, but are included in case of in-field system expansion.
The section Introduction to FIPs describes the various components that make up the FIP.
Refer to the page number listed in this table for information on a specific topic.
Topic See Page #
Introduction to FIPs (4100ES) 2-2
Step 1. Mounting Cabinets (4100ES) 2-9
Step 2. Mounting Card Bays to Cabinets (4100ES) 2-9
Step 3. Configuring Cards (4100ES)
2-11
Step 4. Interconnecting Modules and Bays 2-12
Step 5. Installing Modules into Expansion Bays (4100ES) 2-16
Step 6. Installing LED/Switch Modules into Expansion Bays
(4100ES)
2-21
Chapter 2
Installing 4100ES FIP Components
Introduction
In this Chapter
To Next Page
Loading...
