Name: Simplex 4100ES
Brand: Simplex
Rating: 5 (1 reviews)

To Next Page

To Previous Page

2-6

The Operator Interface lets a user operate the panel. It provides alarm, fault, and isolate

status alerts, and lets the user review historical logs and perform diagnostics.

The 4100ES uses an InfoAlarm graphic display as its user interface.

Figure 2-3. InfoAlarm Operator Interface

Continued on next page

Introduction to FIPs (4100ES), Continued

Operator Interface

Default Chapter3
- End User Liability Disclaimer3
- Non-Disclosure Agreement3
- Amendment Log4
- Model Number & Firmware Revision4
- Cautions, Warnings, and Regulatory Information5
Chapter 1 Introduction to the 4100ES Fire Alarm System16
- System Configurations16
- Standalone Configuration17
- Network Configuration20
Chapter 2 Installing 4100ES FIP Components24
- Step 4. Interconnecting Modules and Bays35
Chapter 3 Installing 4100ES MINIPLEX/RTU Components50
Chapter 4 Networking58
- Getting Started59
- Introduction to the 4100 Network Interface Card (NIC)59
- Step 1. Configuring Network Cards62
- Step 2. Mounting Media Cards to the NIC64
- Step 3. Mounting Network Cards65
- Step 4. Wiring Network Cards66
Chapter 5 The System Power Supply & Alarm Relay Card74
- SPS Specifications75
- SPS Configuration77
- SPS LED Indications78
- Troubleshooting an SPS79
- The Alarm Relay Card80
Chapter 6 SPS Field Wiring (4100ES)82
- General Field Wiring Guidelines83
- SPS NAC Field Wiring Guidelines85
- SPS Auxiliary Power Wiring96
Chapter 7 Idnet Wiring Rules100
- Wiring to Idnet Devices102
Chapter 8 Using Install Mode108
Chapter 9 PC Software Connections114
Chapter 10 Australian Version Specifics116
- Brigade Interfaces121
Chapter 11 Installation Checklist, Commissioning & Maintenance122
- Installation Checklist123
- Alignment and Adjustment124
Appendix B Programming Requirements128
Appendix C Checking System Wiring130
Appendix D Earth Fault Detection132
- General Guidelines133
- Earth Fault Searching from the Front Panel134
- Search Results138
- Earth Fault Search Example140
Appendix E Compatible Actuating Devices142
- List of Approved Devices142
- Compatible Detectors, IDNET145
- Compatible Addressable Field Devices, Idnet146
Appendix F Compatible Batteries148
- Voltage & Current Ratings of Modules & Assemblies151
Appendix J Cable Characteristics154
Appendix K List of Spare Parts156
Appendix L List of Drawings160

Other manuals for Simplex 4100ES

Operator's Manual93 pages

Installation Guide262 pages

Manual8 pages

Operating Instructions8 pages

Quick Start Guide10 pages

Installation Instructions22 pages

Owner's Manual90 pages

Installation Instructions And Operators Manual2 pages

Questions and Answers:

Need help?

Do you have a question about the Simplex 4100ES and is the answer not in the manual?

Simplex 4100ES Specifications

General

Type	Fire Alarm Control Panel
Display	LCD
Battery Backup	Yes
Model	4100ES
Manufacturer	Simplex
Communication Protocol	Optional Ethernet
Signaling Line Circuits (SLCs)	Up to 10
Notification Appliance Circuits (NACs)	Up to 10
Agency Listings	UL, FM, CSFM, MEA
Max Relay Circuits	20
Communication Ports	Ethernet
Operating Temperature	32°F to 120°F (0°C to 49°C)
Humidity	Up to 93% RH, non-condensing