50
Mains wiring
Ensure the 4100ESi is wired with a dedicated current limited mains supply, complying with the requirements
outlined in AS/NZS 3000 Wiring Rules. To meet the Australian electrical safety requirements, the outside
sheath of the mains cable must continue into the body of the mains outlet mounting block.
Adding a MX Loop Card
The 28U and 40U 4100ESi panels are supplied pre-fitted with the number of MX loop cards ordered. Each
loop card supports one loop of up to 250 MX addressable devices. If space is available, it is possible to fit
additional MX loop cards to increase this capacity. It is also possible to fit additional MX loop cards into an
expansion cabinet.
Purchase additional loop cards using part number 4100-6077AU. There is mounting space for up to four MX
Loop cards in an expansion bay.
Flat mounting
The MX Digital Loop Card mounts in a bay in a 28U or 40U cabinet, and connects to the PDI backplane. It is
fastened to the support pillars with the screws supplied in the MX Digital Loop Card kit. Mount the MX Digital
Loop Card in a suitable position on one of the PDI backplanes.
To Next Page
Loading...
Need help?
General
