Simplex 4100ESi Installation Guide

91
Appendix H 4100ESi functions
This appendix lists the following 4100ESi panel functions:
• The AS 7240.2 optional functions with requirements that are and are not supported.
• The functions relating to other parts of AS 7240.
• The ancillary functions not required by AS 7240.2.
Optional functions in AS7240.2
This section cross references the relevant sections in AS 7240.2:
7. Fire alarm condition.
7.8 Output to fire alarm devices — Optional function (see also 9.2.5 and 10.4.2)
YES
.
7.9 Control of fire alarm routing equipment — Optional function (see also 9.2.5)
YES
.
7.10 Output to fire protection equipment — Optional function [see also 9.2.4 f) and 10.4.1 b)]
YES
.
7.11 Delays to outputs — Optional function (see also Annex E)
NO
.
7.12 Dependency on more than one alarm signal — Optional function.
7.12.1 Type A dependency
YES
.
7.12.2 Type B dependency
NO
.
7.12.3 Type C dependency
NO
.
7.13 Alarm counter — Optional function
NO
.
7.14 Output of standard emergency evacuation signal — Optional function
NO
.
8 Supervisory signal condition NO.
9 Fault warning condition (see also Annex F).
9.3 Fault signals from points — Optional function
YES
.
9.4 Total loss of the power supply — Optional function
YES
.
9.9 Output to fault warning routing equipment — Optional function [see also 10.4.1 c)]
YES
.
10 Disabled condition —
Optional function YES
including 10.5 Disablement of addressable points.
11 Test condition — Optional function
NO
12 Standardized input/output interface- Optional function
NO
ANNEX ZB – Alarm Acknowledgment Facility
NO
.
ANNEX ZC – Dry heat Steady State
(OPERATIONAL)
YES
– the nominated temperature is 55°C.

Simplex 4100ESi Specifications

General

Brand	Simplex
Model	4100ESi
Category	Fire Alarms
Language	English