Installation
20220596G 99
Note ! At the completion of the Interface Setup, the names of items that
you have assigned hardware ports to will be available as sources
of data for NAV (navigation), POS (position) and COMPASS in
the USER SETUP MENU. It is recommended that you access the
User Setup Menu directly after completing the Interface Setup to
select the desired data. Refer to page 33 for details on changing
the items in the User Setup Menu.
Output
INSTR J300X-1
5/sec
Radar -------
Note ! The standard NMEA output rate is 1/second. However, in this
autopilot the RSA (rudder angle) sentence is always 5/sec. When
Output INSTR is set to J300X-1 (default), the TX1 (output) port,
will increase the output rate to 5/sec. for the HDM or HDT
(heading) sentences and no other sentences but RSA will be
transmitted from the TX1 port. The output rate may be changed
to 1/second by rotating the course knob. In that case there is no
limitation to the sentences transmitted from TX1.
Abbreviated
name
Assigned
HW
or
To Next Page
Loading...
Need help?
General
