Simrad AP21 User Manual

Installation
20220596G 61
LINEAR DRIVE UNITS
MODEL MOTOR
VOLTS
JUNC-
TION
UNIT
MAX
STROKE
mm (in.)
PEAK
THRUST
kg (lb.)
MAX
RUDDER
TORQUE
Nm
(lb.in.)
HARD-
OVER
TIME
sec.
(30% load)
PWR.
CON-
SUMP.
TILLER
ARM
mm
(in.)
MLD200 12V J3000X 300 (11,8) 200
(440)
490
(4350)
15 1,5-6 A 263
(10,4)
HLD350 12V J3000X 200 (7,9) 350
(770)
610
(5400)
12 2,5-8 A 175
(6,9)
HLD2000L 12V J300X 340 (13,4) 500
(1100)
1460
(12850)
19 3-10 A 298
(11,7)
HLD2000D 24V J300X 200 (7,9) 1050
(2310)
1800
(15900)
11 3-10 A 175
(6,9)
HLD2000LD 24V J300X 340 (13,4) 1050
(2310)
3180
(28000)
19 3-10 A 298
(11,7)
MSD50* 12V J3000X 190 (7,5) 60
(132)
– 15 0,8-2 A –
Steering gear interface: Connects to quadrant or tiller.
* For stern drive power assisted steering only.
1. The motor voltage is stepped down by the junction unit when
operating from 24V or 32V mains (except for RPU1 and
RPU3).
2. The specified junction unit is necessary to achieve max drive
unit capacity.
3. Recommended operational thrust or torque is 70% of listed
value.
4. Typical average power consumption is 40% of listed maximum
value.

Simrad AP21 Specifications

General

Brand	Simrad
Model	AP21
Category	Marine Equipment
Language	English