Video input configuration
Configurations to video input are made in the video panel. Refer to the Operator Manual for
more information.
HDMI out
The HDMI port(s) is used for connecting monitor(s).
The connected monitor should support the resolution listed in the Technical specifications,
or be able to scale.
Ú
Note: Some HDMI TV displays may apply over-scan, which will in effect crop the image
possibly causing loss of important content. Check the display manual for an option to
disable over-scan or adjust scaling.
HDMI connector details
Unit socket (female)
The unit is equipped with standard HDMI (Type A) connector(s).
HDMI cable requirements
Ú
Note: The unit should be turned off prior to connecting or disconnecting an HDMI cable.
While the HDMI standard does not state maximum cable length, signal may be
compromised on long runs. Only use Navico or other high quality HDMI certified cables. 3rd
party cables should be tested before installation. On runs over 10 m it may be required to
add an HDMI amplifier or use HDMI-CAT6 adaptors.
20
Wiring | NSO evo3S MPU Installation Manual
To Next Page
Loading...
Need help?
General
