Simrad NSS evo2 Manual

Restore echosounder defaults
Restore echosounder settings to the factory supplied defaults.
Use depth and temp data from
Selects from which source the depth and temperature data is shared on the NMEA 2000
network.
ForwardScan installation
Available when the ForwardScan feature is connected.
For setup information, refer to the Operator Manual.
LiveSight installation
Available when a LiveSight transducer is connected.
For setup information, refer to the documentation following the LiveSight transducer.
Autopilot settings
The Autopilot settings dialog depends on which autopilot computer that is connected to the
system. If more than one autopilot is connected, the Autopilot settings dialog shows option
for the active autopilot.
The autopilot settings can be split between settings done by the user, and settings done
during installation and commissioning of the autopilot system.
• User settings can be changed for various operational conditions or user preferences.
• Installation settings are defined during commissioning of the autopilot system. No
changes should later be done to these settings.
The following sections describe the installation settings per autopilot computer. For user
settings, refer to the Operator manual.
NAC-1 specific installation settings
Commissioning
Used to calibrate your boat’s steering (cable steer or hydraulic steering) with the NAC-1.
Ú
Note: The autopilot must be commissioned prior to first use and any time after autopilot
default settings have been restored.
Cable steer calibration
Ú
Note: The rudder source must be set to rudder feedback to be able to run this
calibration
Start the calibration process by selecting the rudder feedback calibration option, and follow
the onscreen instructions.
Ú
Note: When centering the motor during the calibration process, ensure that the motor is
centered visually when the dialog shows 0 value. If not, center the motor visually before
pressing OK to align the physical position with the dialog value.
When the calibration process is completed, select the rudder test option to confirm the
calibration.
If the calibration does not pass the rudder test:
• confirm that motor is moving
• confirm that the rudder feedback reading moves according to motor rotation
• check the NAC-1 drive cable
System setup | NSO evo3S MPU Installation Manual
29

Simrad NSS evo2 Specifications

General

Brand	Simrad
Model	NSS evo2
Category	Marine Equipment
Language	English