To Next Page

To Previous Page

5. Select OK to save settings. The Fuel K-Value should now show a new value.

Note: To calibrate multiple engines repeat the steps above, one engine at a time.

Alternatively, run all engines simultaneously, and divide the Actual amount used by the

number of engines. This assumes reasonably even fuel consumption on all engines.

Note: The Calibrate option is only available when Set to full is selected, and a Fuel Flow is

connected and set up as a source.

Note: A maximum of 8 engines is supported using Fuel Flow sensors.

Fuel Level

With the use of a Navico Fluid Level device connected to a suitable tank level sensor, it is

possible to measure the amount of fuel remaining in any equipped tank. The number of

tanks must be set in Vessel Setup dialog, initiated from the Fuel setting options page, to

allow discrete tank assignment of the Fluid Level devices.

Select Device list on the Network page, and view the Device Configuration dialog for each

sensor, and set the Tank location, Fluid type, and Tank size.

For setting up the Instrument bar or a gauge on the Instrument page with Fluid Level device

data, refer to the Operator Manual.

Note: A maximum of 5 tanks is supported using Fluid Level devices.

Note: Tank data that is output by a compatible engine gateway can also be displayed,

however tank configuration for such a data source is not possible from this unit.

Wireless settings

Provides configuration and setup options for the wireless functionality.

This unit does not have built-in WiFi. To connect to the internet or to use the Link app you

must have a compatible external WiFi module connected to the same Ethernet network as

this unit. The following image shows options available when the unit is connected to a

compatible external WiFi module.

For further details about wireless setup and connectivity, refer to the Operator Manual.

Network settings

Device name

Assigning a name is useful in systems using more than one device of the same type and size.

System setup | NSO evo3S MPU Installation Manual

Simrad NSS evo2 Manual

Other manuals for Simrad NSS evo2