System setup
First time startup
When the unit is started for the first time, or after a reset, the unit displays a series of dialogs.
Respond to the dialog prompts to make fundamental settings.
You can perform further setup and later change settings using the system settings dialogs.
Software setup sequence
This setup sequence focus on the settings done during installation and setup of the system.
For other settings refer to the Operator manual.
1 General settings - refer to "System settings" on page 21.
• Make general settings as desired
• Configure the USB ports
• Configure the power control
2 Advanced settings - refer to "Advanced" on page 22.
• Enable or disable features
• Review the advanced setting options and make changes as desired
3 Source selection - refer to "Network settings" on page 32.
• Make sure that the proper external data sources have been selected
4 Feature setup
• Configure specific features as described later in this chapter
The settings dialog
The system setup is done from the settings dialog.
System settings
Boat settings
Used to specify the physical attributes of the boat.
Time
Configure time settings to suit vessel location, along with time and date formats.
PIN code
Sets a PIN code to prevent unauthorized access to your system's settings.
4
System setup | NSO evo3S MPU Installation Manual
21
To Next Page
Loading...
Need help?
General
