Use SOG as boat speed
If boat speed is not available from a paddle wheel sensor, it is possible to use speed over
ground from a GPS. SOG will be displayed as boat speed and used in the true wind
calculations and the speed log.
Use COG as heading
If heading data is not available from a compass sensor, it is possible to use COG from a GPS.
COG will be used in the true wind calculations.
Ú
Note: The autopilot cannot be operated using COG as the heading source. COG cannot
be calculated when stationary.
Alarms
Settings
List of all available alarm options in the system, with current settings.
From this list you can activate, deactivate and change alarm limits.
Siren enable
The Siren enabled option must be set in order for the unit to activate the buzzer when an
alarm condition arises.
Its setting also determines the operation of the external alarm output.
Radar installation
The radar system requires radar sensor specific settings in order to adjust for a number of
variables found in different installations.
Ú
Note: The installation settings available depends on the radar sensor.
Radar source
In a system with more than one radar sensor, the device to configure is selected from this
menu.
Ú
Note: Radars that support dual radar mode are represented twice in the source list, with
an A and B suffix.
Radar status
Displays scanner information and scanner features, primarily used for information and to
assist with fault finding.
System setup | NSO evo3S MPU Installation Manual
23
To Next Page
Loading...
Need help?
General
