Sindoh M400 - LSU; Laser Safety

Paper Delivery Cover
1. Remove the rear cover.
2. Remove 2 bolts on the left and right side on the frame and pull it forward to remove the paper
delivery cover from the machine.
LSU
Laser Safety
CDRH (Center for Devices and Radiological Health) prohibits laser unit repairing on a field. A laser
unit can only be repaired in a factory or necessary places. A laser unit can be replaced with qualified
customer service technician and internal parts of laser unit cannot be replaced on a field. Therefore,
the customer service technician is to return the laser unit to a factory or service center if laser unit’s
parts require replacements.
LSU Information
<L/LF MODEL>
LSU Manufacturer: E-PIN OPTICAL INDUSTRY CO.,LTD.
LSU Form No.: IO-L611-S04
LD Manufacturer: QSI
LD Form No.: QL78C6SA-L
<MF/HF MODEL>
LSU Manufacturer: OSS CO.,LTD..
LSU Form No.: SDH-LSU-A4001
LD Manufacturer: QSI
LD Form No: QL78F6DF
LSU NOTICE
This machine is approved by US for in compliance with DHHS21 CFR Subchapter J regulations for class 1
laser products, and IEC 60825-1 regulations in other countries as well.
Class 1 laser products are considered safe. This machine uses 770~795 nm(L model) and 770~800 nm(M/H
model) frequencies and 5mW(L model) and 15mW(M/H model) output of one AIGaAs laser diode (L model)
and two AIGaAs laser diodes(M/H model).This system and machine are operating properly, but designed to
not to allow accesses to class 1 laser emission under maintenance or regulated service conditions.