8. Using the provided two-part kit of plates, carefully transfer the entire content of the
Print Bed to the plate for carrying the prints, and transfer it to the mold included in the
set. Leave the cuboid with the print to cool down for at least one hour (see image).
Image. A correct way of taking out the prints from the Print Bed
9. Precisely clean the Print Bed from the remaining unsintered powder including the
Beds’ surroundings (it’s highly recommended to move it to the Overflow Bin and then
transfer it to the form with the print).
55 Sinterit Lisa USER MANUAL
To Next Page
Loading...
