● The sintering temperature with Sinterit Lisa Printer is about 100[°C] inside the
chamber. For the provided temperatures, fuming is normal when sintering the above
mentioned powder, although the fumes should not come out of the printer.
● It is forbidden to set or rise the temperature within the printing chamber above 100[°C]
when Flexa Black is inside. In higher temperatures, the powder loses its stability and
becomes liquid which may cause damage to the device.
● The Flexa Black powder must be stored in tight, preferably original, containers; at
room temperature and at a low humidity.
● All of the safety and maintenance conditions for the Flexa Black powder are the same
as for PA12 Smooth (except the refreshing process). Used/unsintered Flexa Black
powder doesn’t need to be refreshed after printing.
C. Powders in Sinterit Studio
PA12 Smooth
All of the basic parameters for working with PA12 Smooth are
already included in Sinterit Studio.
The temperature and
power of the laser
The temperature and power of the laser are automatically set
after selecting PA12 Smooth.
The recommended layer height is 0.125 [mm].
Due to high sintering temperature and a requirement to provide
a uniform temperature, the working area for this powder is
significantly smaller than the Print Bed’s area.
Dimensions: 90 x 130 x 130 [mm] // 3.5 x 5.1 x 5.1 [in]
If the model is dense and the cross-section has large area,
please rotate the model so that the cross-section decreases.
If the model has some details, please orient the detailed
surface upward. The detailed surface will be sharp, while the
bottom surface will be smooth.
If the model has round holes and features, the shape will be
most accurate if the surface is positioned flat.
If the model contains movable parts, please position it
perpendicular/parallel to the printing chamber.
More information in Manual Sinterit Studio - chapter
“Positioning”
71 Sinterit Lisa USER MANUAL
To Next Page
Loading...
