SIPOS AKTORIK SIPOS 5 - Page 33

Y070.020/GB Page 33
Operation instructions
SIPOS 5 PROFITRON, HiMod
5
Commissioning
5 Commissioning
___________________________
* If an end position setting was already performed (e.g. by the valve manufacturer), the question appears in the
display, whether completely new positions have to be set: ”compl. new pos.?“. If not, select the end position
which has to be readjusted, refer also to the following chapter 5.6.4 “Readjusting the end positions“.
5.6.3 Adjusting the end positions
The end positions are directly set at the actuator.
Prerequisite for end position adjustment
■
The valve must not be jammed. Use the crank handle/hand wheel to release it, if necessary. For
the operation of the crank handle/hand wheel refer to chapter 4.1
■
The signaling gear should be set, refer to previous chapter „Adjusting the signaling gear ratio“.
If the signaling gear ratio was not set because the number of revolutions/stroke is not known,
proceed nevertheless as described in the following. Observe the message in the display for ope-
ration step 10 and proceed accordingly.
Initial setting
The end positions must not be set according to a specifi c order. In the following example, the dis-
play messages for end position OPEN are shown. The messages for setting end position CLOSED
are similar.
To cancel the setting procedure, press the buttons simultaneously.
Operation sequence
If the actuator is in the „commissioning“ menu, continue with
operation step 4. For a detailed description of operation step 3,
refer to chapter 5.3, „Access to the commissioning menu“.
1. Remove signaling gear cover.
2. Important: Set the central wheel so that arrows 1 and 2
point in upward direction, see illustration on the right.
3. Call up the main menu in the „locPar“ state, select „commis-
sioning“ menu and enter code 9044.
close direction
clockwise
4. Press
button, until ‚endpos. adjust‘ is indicated in the
display.
endpos. adjust
5. Press ENTER button.
The display changes to the fi rst end position. Use the
buttons to change between end position CLOSED and
OPEN.
start withpos..
open
open
6. Press ENTER button.
The display prompts to approach the end position.
The second line indicates:
– for travel-dependent cut-off mode „press E-button“;
– for torque-dependent cut-off mode „until TL reached“.
Important: When moving to the end position, observe the
direction of rotation of the central wheel. This is important for
operation step 8. From fi rmware version 2.56, an arrow in
the display indicates the direction of rotation.
7. Depending on whether the cut-off mode for the end position
is travel-dependent or torque-dependent, select the following
operation sequence.
move to op.pos.
press E-button