SIPOS AKTORIK SIPOS 5 - Page 34

Operation instructions
SIPOS 5 PROFITRON, HiMod
Page 34 Y070.020/GB
5 Commissioning
5
Commissioning
– Travel-dependent cut-off mode:
a) Observe the valve position and move the actuator with
the OPEN
(CLOSE button for setting in CLOSE di-
rection) suntil the valve has reached the end position.*
Note:
– When pressing the or buttons for a short time
(< 2 s), the actuator moves as long as the push button
is pressed. When held down for a longer time, the
actuator moves, until the STOP (ENTER) button or the
button for the opposite direction is pressed.
– If the cut-off was torque-dependent due to a block,
e.g. in case of a sluggish MOV, an unfavorable torque
curve (cancel by pressing the and buttons simul-
taneously) o this is indicated by“TL-OPEN activ“ or.
„TL-CLOSE activ“ in the second line. The same applies
to approaching the mechanical end stop (return to the
desired end position using the or buttons).
% open open
E +
b) If the correct position for the end position has been
reached, press ENTER to stop the actuator. Perform
possibly required fi ne adjustment with the buttons.
move to op.pos.
press E-button
c) Confi rm position with the ENTER button (for 2SG5…
continue with step 9.).
Symbols in display
– „deviation XX“: continue with step 8.
– ”deviation 0“: Potentiometer adjustment is OK, conti-
nue with operation step 9.
adjust of poti
deviation XX
– Torque-dependent cut-off mode:
Hold down OPEN
(CLOSE button for setting in CLOSE
direction) for more than 2 s! The actuator moves automa-
tically.
% open open
E +
After reaching the end position, the actuator moves shortly
in the opposite direction, to return to the end position
again (for 2SG5 continue with step 9.).
adapting op.pos.
busy...
Symbols in display
– ”deviation XX“: continue with step 8.
– “deviation 0”: Potentiometer adjustment is OK, continue
with operation step 9.
Note: When pressing the
or buttons for a short time
(< 2 s), the actuator moves as long as the push button is
pressed. If the actuator is operated like this, i.e. by pres-
sing the buttons repeatedly for a short time, the cut-off is
not travel-dependent.
adjust of poti
deviation XX
___________________________
* If the actuator has switched off automatically before reaching the end position, two causes are possible:
- Sluggish valve resp. adverse torque behaviour, in this case cancel procedure. Press
and buttons
simultaneously,
or
- valve has reached the mechanical stop; in this case return to the desired end position, press or buttons.