○ Undertake drilling at non-critical, non-
load bearing parts only. Use any available
boreholes. Do not damage lubrication
lines and cables when drilling.
○ Observe possible abrasion points. Protect
the parts accordingly.
○ Ensure through suitable measures that
movable or detached parts are immobi-
lized during the work and that no limbs
can be caught in between by inadvertent
movements.
○ Assemble the product only outside of the
operating range of moving parts, at an
adequate distance from sources of heat
or cold. Other units of the machine or ve-
hicle must not be damaged or impaired in
their function by the installation.
○ Dry or cover wet, slippery surfaces
accordingly.
○ Cover hot or cold surfaces accordingly.
1.14 Transport, installation, maintenance,
malfunctions, repair, shutdown,
disposal
○ All relevant persons must be informed
of the activity prior to starting any work.
Observe the precautionary operational
measures and work instructions.
○ Carry out transport using suitable trans-
port and hoisting equipment on suitable
ways only.
○ Maintenance and repair work can be
subject to restrictions at low or high tem-
peratures (e.g. changed flow properties of
the lubricant). Therefore, where possible,
try to carry out maintenance and repair
work at room temperature.
○ Prior to performing work, the product
and the machine, into which the product
will be integrated, must be depressur-
ized and secured against unauthorized
activation.
- 12 -
951-171-049
Version 02
EN
1. Safety instructions
To Next Page
Loading...
Need help?
General
